30 November, 1999 INSTALLING THE MACHINE
3-1
Installation
3. INSTALLATION
3.1 INSTALLING THE MACHINE
Refer to the Operator's Manual for information about the installation environment
and instructions on how to install and set up the machine.
3.2 INITIAL PROGRAMMING
Items to Program (Service Level) Function No.
Country code (NCU parameter 00) Function 08
Country code (System switch 0F) Function 01
Protocol requirements (G3 switch 0B) Function 01
PABX access code (RAM address 8000BB) Function 06
PABX access method (RAM address 8000AD) Function 06
Machine's serial number Function 14
Service station's fax number Function 13
PM call (System switch 01- bit 0) Function 01
Periodic service call (RAM address 800266) Function 06
Items to Program (User Administrator Level) Function No.
Clock Function 91
Initial programming items Function 61
On/off switches Function 62
Display/report language Function 93
Fusing power control during energy saver mode
(User parameter switch 05 - bit 6)
Function 63
3.3 INSTALLING OPTIONAL UNITS
An optional paper feed unit is available for this machine. Refer to the Operator's
Manual for how to install and set up.
To Next Page
Loading...
