DEDICATED TRANSMISSION PARAMETERS 30 November, 1999
4-46
4.4 DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has four bytes of programmable
parameters allocated to it. If transmissions to a particular machine often experience
problems, store that terminal's fax number as a Quick Dial or Speed Dial, and
adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the four bytes will be
described.
4.4.1 PROGRAMMING PROCEDURE
1. Set bit 3 of System Bit Switch 04 to 1.
2. Either use Function 31 (for a Quick Dial number) or Function 32 (for a Speed
Dial number)
Example:
Change the Parameters in Quick Dial 10.
3.
'6
ê
ì
:
4. Press the Quick Dial key 10.
Note:
When selecting Speed Dial 10 with Function 32, press
ì
í
on the ten
keypad.
5. Press
:
four times.
6. The settings for byte 0 are now displayed. Press a number from 0 to 7
corresponding to the bit that you wish to change.
Example:
Change bit 7 to 1: Press 7
7. To scroll through the parameter bytes, either:
Select the next byte:
á
or
Select the previous byte:
ã
until the correct byte is displayed. Then go back to step 6.
8. After the setting is changed, press
:
.
9. To finish, press
'6
.
10. After finishing, reset bit 3 of System Bit Switch 04 to 0.
To Next Page
Loading...
Need help?
General
