Ricoh FAX2000L - Ncu Parameters (Function 08); Modem Test (Function 08); Dtmf Tone Test (Function 08)

30 November, 1999 SERVICE LEVEL FUNCTIONS
4-5
Service
Tables
4.1.10 NCU PARAMETERS (FUNCTION 08)
1.
'6 ç ì ä ä å
then immediately
:
2.
í å
:
3.
í
4.
Scroll through the parameters using
á
or
ã
. If you want to change a value, enter
the new value at the keypad, then press
:
.
Example:
Set NCU parameter 04 to 005.
á á á á
í í è
:
5. To finish:
/ '6
.
NOTE:
Parameter CC is the Country Code, Parameter 01 is the TX level.
Refer to section 4.3 for full details on NCU parameters.
4.1.11 MODEM TEST (FUNCTION 08)
1.
'6
ç ì ä ä å
then immediately press
:
2.
í å
:
3.
ì
4. Scroll through the available tests using
á
or
ã
.
5.
4
6. To stop the test:
T
7. To finish:
/ '6
4.1.12 DTMF TONE TEST (FUNCTION 08)
1.
'6 ç ì ä ä å
then immediately press
:
2.
í å
:
3.
ë
4. Scroll through the available tests using
á
or
ã
.
FUNCTION KPAD/NEXT>
■■SERVICE FUNCTIONS
0-NCU 1-MODEM
2-DTMF 3-V8
NCU KPAD/<>
NO.04 = 005
FUNCTION KPAD/NEXT>
■■SERVICE FUNCTIONS
0-NCU 1-MODEM
2-DTMF 3-V8
MODEM TEST START/<>
800 Hz
FUNCTION KPAD/NEXT>
■■SERVICE FUNCTIONS
0-NCU 1-MODEM
2-DTMF 3-V8