Ricoh FAX2000L - Service Ram Addresses

30 November, 1999 SERVICE RAM ADDRESSES
4-49
Service
Tables
4.5 SERVICE RAM ADDRESSES
ø
CAUTION
Do not change settings marked as “Not used” or “Read only.”
800001 to 800004(H) - ROM version (Read only)
800001(H) - Revision number (BCD)
800002(H) - Year (BCD)
800003(H) - Month (BCD)
800004(H) - Day (BCD)
800005(H) - RAM Reset Level 1
Change the data at this address to FF (H), then switch the machine off and on to
reset all the system settings.
Caution:
Before using this RAM, print the settings of all the system parameters
(System Parameter List).
800006 to 800016(H)
- Machine's serial number (17 digits - ASCII)
800018(H)
- Total program checksum (low)
800019(H)
- Total program checksum (high)
80001A(H)
- Boot program checksum (low)
80001B(H)
- Boot program checksum (high)
80001C(H)
- Main program checksum (low)
80001D(H)
- Main program checksum (high)
80001E(H)
- RDS program update counter (hex)
800020 to 80003F(H)
- System bit switches
800040 to 80004F(H)
- Scanner bit switches
800050 to 80005F(H)
- Printer bit switches
800060 to 80007F(H)
- Communication bit switches
800080 to 80008F(H)
- G3 bit switches
8000A0(H) - User parameter switch 00
Bit 0 to 3: Not used
Bits 4 and 5: Scanning resolution home position
Bit 5 4 Setting
0 0 Standard
0 1 Detail
1 0 Fine
1 1 Halftone
Bit 6: Transmission mode home position 0: Memory TX, 1: Immediate TX
Bit 7: Not used
8000A1(H) - User parameter switch 01
Bits 0 to 6: Not used
Bit 7: Settings return to home position after transmission 0: Disabled, 1: Enabled