Ricoh FAX2000L - Page 127

SERVICE RAM ADDRESSES 30 November, 1999
4-60
37th byte - Communication modes, byte #2
Bit 0: TX or RX 0: TX, 1: RX
Bit 1: Reduction in TX 0: Not reduced, 1: Reduced
Bit 2: Batch transmission 0: Not used, 1: Used
Bit 3: Send later transmission 0: Not used, 1: Used
Bit 4: Transmission from 0: ADF, 1: Memory
Bits 5 to 7: Not used
38th byte - Number of errors during communication (Hex)
39th to 41st byte - 1st error code and page number where the error occurred
39th byte - Page number where the error occurred (Hex)
40th byte - Error code (low - BCD)
41st byte - Error code (high - BCD)
42nd to 44th byte - 2nd error code and page number where the error occurred
45th to 47th byte - 3rd error code and page number where the error occurred
48th to 50th byte - 4th error code and page number where the error occurred
51tst to 53rd byte - 5th error code and page number where the error occurred
806126 to 806265(H)
- Dedicated tx parameters for Quick Dial 01 - 30 and Speed
Dial #00 - #49.
As explained in section 4.4, each set of dedicated tx parameters consists of 8
bytes.
806126 to 806129(H) - Dedicated tx parameters for Quick 01
80612A to 80612D(H) - Dedicated tx parameters for Quick 02
80612E to 806131(H) - Dedicated tx parameters for Quick 03
:
80619A to 80619D(H) - Dedicated tx parameters for Quick 30
80619E to 8061A1(H) - Dedicated tx parameters for Speed #00
8061A2 to 8061A5(H) - Dedicated tx parameters for Speed #01
8061A6 to 8061A9(H) - Dedicated tx parameters for Speed #03
:
806262 to 806265(H) - Dedicated tx parameters for Speed #49
F80006 to F8000E(H) - ROM part number and suffix (ASCII)