Ricoh FAX2000L - Page 87

BIT SWITCHES 30 November, 1999
4-20
System Switch 12
No FUNCTION COMMENTS
0
to
7
TTI printing position in the
main scan direction
08 to 92 (BCD) mm. Only input even numbers.
This setting determines the TTI print start
position from the left edge of the paper. If the
TTI is too far to the right, the file number, which
is on the top right of the page, may obscure it.
System Switch 13 - Not used (do not change any of these settings)
System Switch 14 - Not used (do not change any of these settings)
System Switch 15
No FUNCTION COMMENTS
0
Not used Do not change this setting.
1 Programming with European
characters
0: Disabled 1: Enabled
1: The user can program with European
characters (e.g. ”ä”, ”å”) for the TTI, Quick Dial
labels, etc.
2-7
Not used Do not change these settings.
System Switch 16 - Not used (do not change any of these settings)
System Switch 17
No FUNCTION COMMENTS
0
Not used Do not change this setting.
1
Direct fax number entry
0: Disabled 1: Enabled
0: The user must place the original on the ADF
before dialing.
2-7
Not used Do not change these settings.
System Switch 18 - Not used (do not change any of these settings)
System Switch 19 - Not used (do not change any of these settings)
System Switch 1A - Not used (do not change any of these settings)
System Switch 1B - Not used (do not change any of these settings)
System Switch 1C - Not used (do not change any of these settings)
System Switch 1D - Not used (do not change any of these settings)
System Switch 1E - Not used (do not change any of these settings)
System Switch 1F - Not used (do not change any of these settings)