BIT SWITCHES 30 November, 1999
4-26
Communication Switch 02
No FUNCTION COMMENTS
0 Burst error threshold
0: Low
1: High
If the received page has more consecutive error
lines than the threshold, the machine sends a
negative response.
The low and high threshold values depend on
the sub-scan resolution, and are as follows.
Resolution Standard Detail
Low settings 6 12
High settings 12 24
This bit is ignored if ECM is in use.
1
Acceptable total error line ratio
0: 5%
1: 10%
If the error line ratio of a page exceeds the
acceptable ratio, RTN will be sent to the other
end.
This bit is ignored if ECM is in use.
2 Treatment of pages received
with errors during G3 reception
0: Deleted from memory
without printing
1: Printed
0: Pages received with errors are not printed.
3
Hang-up decision after
receiving a negative code
(RTN or PIN) during G3
immediate transmission
0: No hang-up
1: Hang-up
0: Sends the next page even if RTN or PIN is
received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
4-7
Not used Do not change these settings.
Communication Switch 03
No FUNCTION COMMENTS
0
to
7
Maximum number of page
retransmission in a G3
memory transmission
00 - FF (Hex) times.
This bit is ignored if ECM is in use.
Communication Switch 04 - Not used (do not change any of these settings)
Communication Switch 05 - Not used (do not change any of these settings)
Communication Switch 06
No FUNCTION COMMENTS
0
Dialing requirements:
Germany
0: Disabled 1: Enabled
1
Dialing requirements: Austria
0: Disabled 1: Enabled
2
Dialing requirements: Norway
0: Disabled 1: Enabled
This function automatically sets these switches
to the required settings for each country after
selecting a country code (System Switch 0F).
To Next Page
Loading...
