Ricoh G800 - Page 150

149
Wireless Networks (G800SE Only)
14
3
Add host configurations.
• Repeat Steps 1 and 2 to add or edit other host configurations. The
current configuration can be renamed by clicking [Rename] or
deleted by clicking [Delete].
4
Click [Apply].
• Click [Apply] to save the communication list.
5
Connect the camera to the computer.
• Turn the camera off and connect it to the computer using the
supplied USB cable. The camera will turn on automatically.
6
Click [Transfer to Camera].
• Enter the camera password when
prompted and click [OK] to begin
transfer. If you wish to update a
communication list already present
on the camera, click [Yes] when
prompted. If you did not click [Apply]
in Step 4, you will also be prompted
to save the communication list; click
[OK].
7
Click [OK] when transfer is complete.
• A message will be displayed when transfer is complete; click [OK].
8
Exit ST-10.
• Click [OK] in the ST-10 window to exit ST-10.
• Remove the camera from the system and disconnect the USB cable.
9
Select [Import Communication
Setting].
• After turning the camera on, highlight
[Import Communication Setting] in the
expanded settings menu (GP.118) and
press $. A confirmation dialog will be
displayed.