32
If you are using the camera for the first time, read this section.
Setting the Language
1
Press the !" buttons to select a
language.
• When the DISP. button is pressed, the
language setting is canceled and the
date/time setting screen appears.
2
Press the MENU/OK button.
• The display language is set, and the date/time setting screen appears.
Setting the Date and Time
1
Press the !"#$ buttons to set the year, month, date, time
and format.
• Change the setting with !" and move
the item with #$.
• You can cancel the setting by pressing
the DISP. button.
2
Check the information on the
screen and then press the MENU/
OK button.
• The confirmation screen appears.
3
Press the MENU/OK button.
• The date and time are set.
• If the battery is low, a warning will be displayed. Use of a fully-
charged battery is recommended; to clear the warning from the
display, press MENU/OK.
Note -------------------------------------------------------------------------------------
• The language, date, and time can be changed at any time using the
[Language/N] and [Date Settings] items (GP.100) in the setup menu
(GP.95).
• The [Date Imprint] item (GP.75) in the shooting menu (GP.72) can be used to
stamp photographs with the date and time of recording.
• If the battery is removed for more than three days, the date and time settings
will be lost. These settings must be made again.
• To retain the date and time settings, load a battery with adequate remaining
power for more than ten hours.
To Next Page
Loading...
