Notices 146
Laser notice
The printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR, Chapter I, Subchapter J for
Class I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the requirements of
IEC 60825-1: 2014 (JIS C 6802:2018).
Class I laser products are not considered to be hazardous. The laser system and printer are designed so there is
never any human access to laser radiation above a Class I level during normal operation, user maintenance, or
prescribed service conditions. The printer has a non-serviceable printhead assembly that contains a laser with the
following specifications:
Class: IIIb (3b) AlGaAs
Nominal output power (milliwatts): 8
Wavelength (nanometers): 770–800
Power consumption
Product power consumption
The following table documents the power consumption characteristics of the product.
Note: Some modes may not apply to your product.
Power consumption (Watts)
The product is generating hard-copy output from
electronic inputs.
One-sided: 385 (1500-218), 395 (1500-638), 400
(1500-836, 1500-8c6, 1500-8c9)
Two-sided: 260 (1500-218), 275 (1500-638, 1500-
836, 1500-8c6, 1500-8c9)
The product is generating hard-copy output from
hard-copy original documents.
The product is scanning hard-copy documents.
The product is waiting for a print job.
15.5 (1500-218), 15 (1500-638), 17 (1500-836, 1500-
8c6, 1500-8c9)
Mode
The product is in a high-level energy-saving mode.
0.9 (1500-218, 1500-638), 1.2 (1500-836, 1500-8c6,
1500-8c9)
The product is in a low-level energy-saving mode.
The product is plugged into an electrical outlet, but
the power switch is turned off.
The power consumption levels listed in the previous table represent time-averaged measurements. Instantaneous
power draws may be substantially higher than the average.
To Next Page
Loading...
