RX Settings
Stop/Clear key
Pressing the Stop/Clear key can stop the current
receiving operation. Received data is lost.
[No Functional (Default)/ Functional]
Off-Hook Level
DFU (Designed for Factory Use)
Do not change this setting.
[10V (Default)/ 15V/ 20V/ 25V]
Off-Hook Detection
Period
Sets the Off-Hook detection period.
200 ms (default)
800 ms
Number for
Remote Switch
-
[0 to 9 / - / 1step]
Number of time to
press
-
[1 to 3 / - / 1step]
Period for TEL to
FAX
-
[Limitless / 10 sec / 20 sec / 30 sec/ 40 sec]
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times/ 3 Times/ 4 Times/ 5 Times]
Overseas Comm
Mode Settings
Overseas Comm
Mode
This sets the machine to ignore a DIS signal sent from the
called station once in a sending operation.
[Off (Default)/ Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects the CNG
signal after the line is connected. If it is set to "Off", the
machine detects the CNG signal as long as the line is
connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
5. System Maintenance Reference
138
To Next Page
Loading...
