Ricoh PE-P4 - Scanner Unit (Only for MF Models); Scanner Unit

Scanner Unit (only for MF Models)
Scanner Unit
1. Rear cover (page 32 "Rear Cover")
2. Controller box cover (page 99 "Controller Board")
3. Remove the left stand cover [A] and right stand cover [B]. (hook × 1 each)
4. Disconnect the two flat cables [C] with the ferrite core [D] ( ×2, 2 hooks).
5. Disconnect the three harnesses and ground wire from the left stand. ( × 3, × 1)
4. Replacement and Adjustment
38