Copying
98
2
E Set the erase center width with [n] and [o].
Pressing [n] or [o ] changes the width in increments of 1 mm (0.1 inch).
Pressing and holding down the relevant key changes the width in increments
of 10 mm (1 inch).
If you select to erase the image on the back of the original, press [2 Sided Set-
ting] and [Back].
Erasing the image on the back is valid when you copy 2-Sided originals.
F Press [OK] twice.
G Place the originals, and then press the {Start} key.
Center/Border Erase (same width)
This mode erases both the center and edge margins of the original image.
A Press [Edit / Stamp].
B Press [Erase].
C Press [Erase Center / Border].
D Press [Erase Center/ Border].
E Press [Same Width].
To Next Page
Loading...
Need help?
General
