EasyManuals Logo

Ricoh Printer/Scanner Unit Type 8000 User Manual

Ricoh Printer/Scanner Unit Type 8000
907 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #355 background imageLoading...
Page #355 background image
Copying
100
2
E Press [Different Width].
F Press the key you want to change and set an erase width with [n] and [o].
Pressing [n] or [o ] changes the width in increments of 1 mm (0.1 inch).
Pressing and holding down the relevant key changes the width in increments
of 10 mm (1 inch).
If you select to erase the image on the back of the original, press [2 Sided Set-
ting] and [Back].
Erasing the image on the back is valid when you copy 2-Sided originals.
G Press [OK] twice.
H Place the originals, and then press the {Start} key.
Inside Erase
This mode erases a designated area of the copy image.
A Specify the point where the machine starts scanning (X1, Y1) and where it
stops scanning (X2, Y2).
You can input lengths of 0 - 432 mm, 0 - 17".
B Press [Edit / Stamp].
C Press [Erase].
D Select one of the areas from [Erase Inside 1] to [Erase Inside 5].

Table of Contents

Other manuals for Ricoh Printer/Scanner Unit Type 8000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh Printer/Scanner Unit Type 8000 and is the answer not in the manual?

Ricoh Printer/Scanner Unit Type 8000 Specifications

General IconGeneral
BrandRicoh
ModelPrinter/Scanner Unit Type 8000
CategoryAll in One Printer
LanguageEnglish

Related product manuals