Appendix
192
5
• You cannot change stapling positions during copying.
• When the original image is rotated, the staple orientation changes by 90°.
• When [Top] or [Bottom] is selected and the paper with the same orientation
as the original is not loaded, the image is rotated and the paper with the
same size and the different orientation is selected.
• With certain stapling settings, you cannot use the Rotate function.
• If you select the Saddle Stitch function with the Booklet finisher, the machine
staples and folds the paper in the center, then delivers the paper folded.
• If you select the Saddle Stitch function in Magazine mode, the machine sta-
ples the paper, and folds it like a book, then delivers the paper folded.
❖ Punch
• When using Punch and Combine, Double Copies, or Auto Reduce/En-
large, the message “Blank part will appear. Check orientation.” may ap-
pear because of the orientation of the original and the copy paper. If this
occurs, change the orientation of the copy paper.
• Punchable paper sizes are as follows:
❖ Z-fold
• You cannot use the following copy paper with this function:
• Recycled paper
• Special paper
• Translucent paper
• Letterhead
• Thick paper
• Color paper 1
• Color paper 2
•Tab stock
• OHP transparencies
• Label paper (adhesive labels)
•Postcards
• Paper fed from the interposer cannot be Z-folded.
Punch Unit Type Orienta-
tion
Paper Size
2 holes type L
A3 - A5, 11" × 17", 8
1
/
2
" × 11"
K
A4 - A5, 8
1
/
2
" × 11"
3 holes type L A3, B4 JIS, 11" × 17"
K
A4, B5 JIS, 8
1
/
2
" × 11"
4 holes type L A3, B4 JIS, 11" × 17"
K
A4, B5 JIS, 8
1
/
2
" × 11"
To Next Page
Loading...
Need help?
General
