Transmission
102
1
D Confirm the selected sender, and then press [OK].
E To print the sender's name on the receiver's sheet, press [Stamp Sender Name]
to highlight it.
If you enable this function, the sender's name (user name) appears on the re-
ceiver's sheet, lists, and report.
F To confirm the transmission results by e-mail notification, press [E-mail TX
Results] to highlight it.
If the sender's e-mail address is registered, you can send the transmission re-
sult to the registered e-mail address.
G Press [OK].
The standby display appears.
To check the settings, press [Sender Name].
H Specify the destination, and then press the {Start} key.
To Next Page
Loading...
Need help?
General
