Printer driver setup Click [Plain] or [Plain/Recycled] in the "Paper type:" list.
Enabled paper feeding tray Any input tray can be used.
Number of sheets that can be set Tray 1: 500
Tray 2, Tray 3 (Paper Feed Unit): 500
Bypass Tray: 100
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Both-sided printing Possible
Additional cautions When printing on 91 - 130 g/m
2
paper, print speed is slightly
slower to when printing on paper of 60 - 91 g/m
2
.
Letterhead
Printer setup Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Letterhead] for the selected tray's paper type.
Printer driver setup Click [Letterhead] in the "Paper type:" list.
Both-sided printing Possible
Thick Paper
Paper thickness 130 - 162 g/m
2
(8 - 43 lb.)
Printer setup Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Thick Paper] for the selected tray's paper type.
Printer driver setup Click [Thick] in the "Paper type:" list.
Enabled paper feeding tray Any input tray can be used.
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Paper Recommendations
89
To Next Page
Loading...
