msh> autonet {on|off}
• {on} means "active" and {off} means "inactive".
Current interface priority configuration display
msh> autonet priority
Interface priority configuration
msh> autonet priority "interface_name"
• You can give interface's AutoNet parameter priority.
• Priority settings are available when multiple interfaces are installed.
• wlan can be specified only when the wireless LAN interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan Wireless LAN interface
• If an interface is not selected, the current interface connection settings remain in effect.
• For details about AutoNet, refer to autonet parameters.
bonjour
Use the "bonjour" command to display bonjour-related settings.
View settings
Bonjour settings are displayed.
msh> bonjour
Bonjour service name setting
You can specify the bonjour service name.
msh> bonjour cname "computer name"
• The computer name can be entered using up to 63 alphanumeric characters.
Bonjour Installation location information setting
You can enter information about the location where the printer is installed.
msh> bonjour location "location"
• Information about location can be entered using up to 32 alphanumeric characters.
Setting order of priority for each protocol
• diprint
Remote Maintenance by telnet
223
To Next Page
Loading...
