Ricoh Printer - Deactivating Ipsec Using the Control Panel

IPsec SA (phase 2) PFS setting
msh> ipsec ike {1|2|3|4|default} ph2 pfs {none|1|2|14}
• Enter the separate setting number [1-4] or [default] and specify the IPsec SA (phase 2) Diffie-
Hellman group number.
• Specify the group number to be used.
• Not specifying a group number displays the current setting.
IPsec SA (phase 2) validity period setting
msh> ipsec ike {1|2|3|4|default} ph2 lifetime validity period
• Enter the separate setting number [1-4] or [default] and specify the IPsec SA (phase 2) validity
period.
• Enter the validity period (in seconds) from 300 to 172800.
• Not specifying a validity period displays the current setting.
Reset setting values
msh> ipsec ike {1|2|3|4|default|all} clear
• Enter the separate setting number [1-4] or [default] and reset the specified setting. Specifying
[all] resets all of the settings, including default.
Deactivating IPsec Using the Control Panel
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to display [Host Interface], and then press the [ Enter] key.
3. Press the [ ] or [ ] key to display [Network Setup], and then press the [ Enter] key.
4. Press the [ ] or [ ] key to display [IPsec], and then press the [ Enter] key.
5. Press the [ ] or [ ] key to display [Not Active], and then press the [ Enter] key.
IPsec is now deactivated.
8. Security Measures Provided by this Printer
372
8