Loading envelopes onto the Bypass Tray
• Confirm that the envelope flaps are securely folded down, and that there is no air inside the envelopes.
1. Load envelopes until they stop, with the print side up and the sides of the flaps on the left as
shown below.
2. Slide the side guides against the edge of the envelope stack.
3. Set the envelope size and feed direction. Press the [Menu] key.
The [Menu] screen appears.
4. Press the [ ] or [ ] key to display [Paper Input], and then press the [ Enter] key.
5. Check [Bypass Size] appears, and then press the [ Enter] key.
6. Press the [ ] or [ ] key to select the envelope type, and then press the [ Enter] key.
5. Paper and Other Media
112
To Next Page
Loading...
