• See p.71 "Wireless LAN Configuration".
Error: Enter 5 or 13 characters
The entered number of characters for the WEP Key (ASCII entry) is incorrect.
• Enter the correct WEP key.
• See p.71 "Wireless LAN Configuration".
Hardware Problem Ethernet
The printer detected an ethernet error.
• Turn the power off, and then on. If the message appears again, contact your sales or service
representative.
Hardware Problem HDD
The printer identified a HDD Board error.
• Turn the power off, and then on. Remove and re-install the HDD board correctly. If the message
appears again, contact your sales or service representative.
• See p.32 "Installing the Memory Expansion Units".
Hardware Problem Option RAM
The printer detected an optional RAM error.
• Turn the power off, and then on. Remove and re-install the optional RAM. If the message appears
again, contact your sales or service representative.
• See p.32 "Installing the Memory Expansion Units".
Hardware Problem Parallel I/F
The printer identified a parallel interface error.
• Check the correct interface cable being used.
• Turn the power off, and then on. If the message appears again, contact your sales or service
representative.
Hardware Problem Printer font
The printer identified a printer font file error.
• Replace the printer font module.
Hardware Problem USB
The printer identified a USB I/F Board error.
• Turn the power off, and then on. If the message appears again, contact your sales or service
representative.
Invalid Password Try again
The invalid password was entered and Locked or Stored Print is incorrect.
Error & Status Messages on the Control Panel
163
To Next Page
Loading...
