Vacuum Fan Shutter
Turn on or off the vacuum fan shutter in Wide Large Capacity Tray. If [On] is set, the fan operates
according to the paper fed timing. [Off] enables constant operation of the fan.
Setting Item Values
38: Setting Off
On
1303: 2-Tray LCIT: Other Settings
Adjust feed timing by setting wait time of blowing to float paper in Wide Large Capacity Tray.
* If double feed occurs at the start of the job, set a longer time for waiting.
Setting Item Max. Value Min. Value Step Unit
01: Paper Floating Wait Time 5 3 0.1 second
Extend Fan Operating Time
Set to [On (Improve Separation)] for paper that is likely to double feed or not feed. Setting a longer fan
operating time improves separation. However, the paper feed interval is longer, which may lower
productivity.
Setting Item Values
02: Setting Off
On (Improve Separation)
Prevent Initial Nonfeed
Set to [On] for paper that is likely to not feed immediately after printing starts, but which is not improved
by setting [Prevent Non Feed] in [Paper Feed Mode: Fan Level]. Elevating the bottom plate of the tray
immediately after printing starts helps to prevent non-feeding.
4. Adjustment Setting Items for a Custom Paper
190
To Next Page
Loading...
