Setting Item Values
03: Setting Off
On
Tray Elevation Assist
Set the timing at which tray elevation assist starts.
Setting Item Values
04: Assist Mode Off
Assist On When Remaining Paper Low
Always Assist On
Specify the thickness of paper (measured value) when you specify [Always Assist On] or [Assist On
When Remaining Paper Low] in [Assist Mode].
An initial value is specified by default when you are not entering the value that you measured on paper
in [Paper Thickness]. Do not change the default value in the case.
Setting Item Max. Value Min. Value Step Unit
05: Paper Thickness 2,000 20 10 m
Specify the ascending speed of the tray when you specify [Always Assist On] or [Assist On When
Remaining Paper Low] in [Assist Mode].
Setting Item Values
06: Speed Slowest
Slower
Standard
Faster
Fastest
1312: Main/Bypass
Set the operation of the paper feed roller of Main Tray and Bypass Tray. If [On] is set, contact time of
the roller is extended according to the paper type and paper weight.
13: Machine: Paper Feed/Output
191
To Next Page
Loading...
