8. Load the paper so that it is not stacked above the upper limit marks on the auxiliary side fences
and end fence.
10. Close the Banner Sheet Tray Top Board.
11. Close the cover of Extension LCT banner sheet tray.
• Remove and store the auxiliary fences or fence from the machine when you are not using them.
Loading Paper into the Interposer
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
1. While pressing the release lever, align the fences with the paper to be loaded.
2. Load paper orderly.
Do not stack paper over the limit mark.
The interposer tray automatically starts the operation shortly after loading paper. Adjust the fences
before that.
Align the fences gently against the paper you loaded, if necessary.
Loading Paper into the Paper Tray
95
To Next Page
Loading...
