The password policy setting is effective only if [Basic Auth.] is specified.
This setting lets you specify [Complexity Setting] and [Minimum Character No.] for the password. By
making this setting, you can limit the available passwords to only those that meet the conditions
specified in "Complexity Setting" and "Minimum Character No.".
If you select [Level 1], specify the password using a combination of two types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
If you select [Level 2], specify the password using a combination of three types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
Default: [Off]
Passwords can contain the following characters:
• Upper-case letters: A to Z (26 characters)
• Lower-case letters: a to z (26 characters)
• Numbers: 0 to 9 (10 characters)
• Symbols: (space) ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _` { | } (33 characters)
Some characters are not available, regardless of whether their codes are entered using the keyboard
or the control panel.
@Remote Service
This can be specified by the machine administrator.
Communication via HTTPS for @Remote Service is disabled if you select [Prohibit].
Default: [Do not Prohibit]
Update Firmware
This can be specified by the machine administrator.
Specify whether to allow firmware updates on the machine. Firmware update means having the service
representative update the firmware or updating the firmware via the network.
If you select [Prohibit], firmware on the machine cannot be updated.
If you select [Do not Prohibit], there are no restrictions on firmware updates.
Default: [Do not Prohibit]
Change Firmware Structure
This can be specified by the machine administrator.
Specify whether to prevent changes in the machine's firmware structure. The Change Firmware
Structure function detects when the SD card is inserted, removed or replaced.
If you select [Prohibit], the machine stops during startup when a firmware structure change is detected
and a message requesting administrator login is displayed. After the machine administrator logs in,
the machine finishes startup with the updated firmware.
8. Specifying the Extended Security Functions
194
To Next Page
Loading...
