2. Enter "http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
The machine administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [User Lockout Policy] under "Security".
5. Set "Lockout" to [Active].
6. In the drop down menu, select the number of login attempts to permit before applying
lockout.
7. After lockout, if you want to cancel lockout after a specified time elapses, set "Lockout
Release Timer" to [Active].
8. In the "Lock Out User for" field, enter the number of minutes until lockout is disabled.
9. Click [OK].
10. Click [Logout].
Canceling Password Lockout
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
The administrator or supervisor with unlocking privileges can log in.
Enter the login user name and login password.
4. Click [Address Book].
5. Select the locked out user's account.
6. Click [Change].
7. Set "Lockout" to [Inactive] under "Authentication Information".
8. Click [OK].
9. Click [Logout].
• You can cancel the administrator and supervisor password lockout by turning the power off and then
turning it back on again, or by canceling the setting in [Program/Change Administrator] under
[Configuration] in Web Image Monitor.
3. Configuring User Authentication
70
To Next Page
Loading...
