Ricoh Pro C9500 - Page 10

09: Finishing: Stacker.................................................................................................................................... 220
0901: Paper Alignment in Stacker Tray: Across Feed 1........................................................................220
0902: Paper Alignment in Stacker Tray: Across Feed 2........................................................................220
0903: Paper Alignment in Stacker Tray: With Feed.............................................................................. 221
0904: Paper Alignment in 2nd Stacker Tray: Across Feed 1................................................................222
0905: Paper Alignment in 2nd Stacker Tray: Across Feed 2................................................................223
0906: Paper Alignment in 2nd Stacker Tray: With Feed...................................................................... 224
0907: Maximum Stack Quantity in Stacker Tray...................................................................................224
10: Density Difference Printing: Across Feed.............................................................................................. 226
21: Finishing: Interposer................................................................................................................................227
2101: Detect JAM573............................................................................................................................. 227
2101: Detect JAM574............................................................................................................................. 227
2102: Interposer Fan Setting................................................................................................................... 227
6. Troubleshooting
Alert Sounds...................................................................................................................................................229
Checking the Messages Displayed on the Control Panel.......................................................................... 230
When an Alarm Icon Is Displayed...........................................................................................................230
When the Machine Cannot Be Operated...................................................................................................232
When a Message Appears and the Machine Cannot Be Operated........................................................233
When Machine Login Fails........................................................................................................................... 235
When Paper Is Jammed................................................................................................................................ 236
When the Animation Does Not Appear..................................................................................................237
Ejecting the Paper Jammed in the Post Processor Unit Automatically................................................... 248
When a Staple Is Jammed............................................................................................................................ 250
Booklet Finisher..........................................................................................................................................251
Booklet Finisher (Saddle Stitch)................................................................................................................252
When the Hole Punch Receptacle Is Full..................................................................................................... 253
Removing Staple Waste................................................................................................................................254
Removing Waste Paper.................................................................................................................................255
When a Deviation in Color Registration Appears...................................................................................... 256
7. Specifications for The Machine
Model-Specific Information.......................................................................................................................... 257
Specifications for the Main Unit................................................................................................................... 258
8