Message Explanation Recommended Action
TypeMsmtch:#Start/JobReset The paper type setting in the
tray # (1, 2, bypass) differs
from that of actual paper type in
the tray.
Load paper of the selected type
in the tray, and then press the
[Stop/Start] key to continue
printing.
Press the [Job Reset] key to
cancel printing.
Move Env. Lever The fusing unit levers are not
positioned correctly.
When printing on an envelope,
check that the left and right
levers have been lowered to the
envelope mark.
When printing on paper, check
that the left and right levers have
been raised to the plain paper
mark.
Cover Open The top or front cover is open. Open and then close the top or
front cover.
Controller FW Download failed Controller FW could not be
downloaded.
Turn off the main power, turn it
back on, and then download
the controller FW again.
If the download fails again,
contact your sales or service
representative.
Incorrect Tnr: # Irregular toner # (Black,
Magenta, Cyan or Yellow) is
set.
Replace the toner to an
appropriate one. See
page 127 "Replacing the Print
Cartridge".
If the error message appears
even though the toner cartridge
is attached correctly, use a dry
cloth to wipe the part of the
toner cartridge that is in contact
with the machine.
Load Paper # The indicated tray # (1, 2,
bypass) is out of paper.
Load paper into the indicated
paper tray.
See page 26 "Loading Paper".
7. Troubleshooting
152
To Next Page
Loading...
Need help?
General