Blank Pg. Print
Sets the printer to print blank pages.
Note that this setting has lower priority than the printer driver's blank page setting.
When cover sheet printing is enabled from the printer driver, cover sheets are inserted even if you
select [Off].
Default: [On]
• On
• Off
Energy Saver 1
The machine enters Energy Saver mode 1 if the machine has been idle for about 30 seconds. It
takes less time to recover from Energy Saver mode 1 than from power-off state or Energy Saver
mode 2, but power consumption is higher in Energy Saver mode 1 than in Energy Saver mode 2.
Default: [Off]
• Off
• On (30 seconds)
Regardless of the settings for Energy Saver 1 or EnergySaver 2, the machine enters EnergySaver 1
after being idle for 10 minutes.
Energy Saver 2
The machine enters Energy Saver mode 2 after the period of time specified for this setting is
passed. The machine consumes less power in Energy Saver mode 2 than in Energy Saver mode 1,
but it takes longer to recover from Energy Saver mode 2 than from Energy Saver mode 1.
Default: [On] (1 minute)
• On (1 to 240 minutes, in 1 minute increments)
• Off
B&W Page Detect
Sets the printer to print all monochrome pages in monochrome mode even if color printing is
specified.
Default: [On]
• On
• Off
Restore Default
Resets the printer settings to their factory-set defaults.
Prt. Err.Report
Sets the printer to print an error page when the printer detects a printer or memory error.
Default: [Off]
4. Configuring the Machine Using the Control Panel
84
To Next Page
Loading...
Need help?
General