71
20152192
Appendix - Accessories
Output power regulator kit for modulating operation
With the modulating operation, the burner continually adapts the
power to the heat request, ensuring a high level of stability for the
parameter controlled: temperature or pressure.
Two components should be ordered:
– the output power regulator to be installed on the burner;
– the probe to install on the heat generator.
Software diagnostics kit
A special kit is available that, by an optical link to a PC, shows the
burner life together with operating hours, type and number of
lockouts, number of motor rpm's and safety parameters.
To view diagnostics, proceed as follows:
connect the kit (supplied separately) to the appropriate
socket on the control box. Reading of the information begins
when the software programme included in the kit starts.
A Appendix - Accessories
Burner Output regulator Code
RX 700-850-1000S/PV RWF50.2 20094733
Burner Probe Adjustment field Code
RX 700-850-1000S/PV
Temperature PT 100 - 100 ÷ 500° C 3010110
Pressure 4 ÷ 20 mA 0 ÷ 2,5 bar 3010213
Pressure 4 ÷ 20 mA 0 ÷ 16 bar 3010214
Pressure 4 ÷ 20 mA 0 ÷ 25 bar 3090873
The installer is responsible for the addition of any
safety device not foreseen in this manual.
Burner Code
RX 700-850-1000S/PV on demand
To Next Page
Loading...
