Rigol DG3000 Series

RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for Logic Signal Output Module
2-27
To Set the Output Data Length
Press Arb  Edit Digital W  F5, to enter the second page of “DIGIT”. Press
Output Length to set the output data length as shown in Figure 2-27.
Figure 2-27 Set the output data length
PROMPT
 Output Length: To define the output data length (Byte). Different protocols
have different upper limit.
 If current the current output code is User code, then User code plus User
offset can not exceed User space and the upper limit of protocol output, in
addition, not to exceed 256k Bytes.
 RS232 output upper limit: 35k Bytes; SPI output upper limit: 40k Bytes; IIC
output upper limit: 10k Bytes; PO output upper limit: 128k (1k=1024) Byte.