RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for Logic Signal Output Module
To Connect the Module
The Logic Signal Output Module is an optional accessory of the DG3000 Series
Function/Arbitrary Waveform Generator. Connect the module to a DG3000 as
shown in Figure 1-5. Make sure that the power is off before and during the
connection. Power up the instrument, the DG3000 will confirm if the module has
been successfully installed by displaying the message: “Digital module is installed”.
Otherwise, repeat the above setup process until the screen shows the success
message.
Figure 1-5 Connect the module to DG3000
WARNING When connecting the module to a DG3000, the power must
be turned off.
To Next Page
Loading...