Rigol DG3000 Series

To Next Page

To Previous Page

RIGOL

User‟s Guide for Logic Signal Output Module

1-6

DG3000 provides a switch function to control the power modes of the module.

Press Utility  Output Setup  Digit-Modu, as shown in Figure 1-6, there are

two power states: “Power-On” and “Power-Off”.

The module supports two work modes: “Depend” and “Independ”.

At the “Depend” mode, all the analog waveforms output are disabled, the output

rate and phase of digital output will have not limit.

At the “Independ” mode, both the module and DG3000 can works normally.

However, the output rate and phase of module will have “some limit” (See the

following prompt message).

Figure 1-6 Choose “Independ” mode

Examples in this manual use the “Independ” mode to introduce the functions and

operation methods of the module, as shown in Figure 1-6 Choose “Independ”

mode, the Arb button will blink indicating that the modified settings have not

been activated, Press Arb again to execute.