Error Message
1. Please select a valid File. You are trying reading analog wave into
digital space; please confirm you are working under analog space.
When users recall analog waveform at digital waveform editor interface; this
message will appear.
2. Please select a valid File. You are trying reading digital wave into
analog storage space, or please confirm you are working under the
analog waveform edit it.
Press Store/Recall , enter the STORAGE menu, and choose a stored digital
waveform to recall; this message will appear.
3. Invalid operation. Digital logic output module is under co-operation
working with DG series.
If the current work mode is “Depend”, analog waveform is disabled. Press any
function key of analog wave; this message will appear.
4. Invalid operation. Digital logic output module is power off.
If the digital module is power-off, pressing Utility Output Setup F5 F3
(Work- mode); this message will appear.
5. Please power on the digital logic module
If the digital module is power-off, press Arb , choose Edit Digital W and press
Arb again; this message will appear.
6. The address of 16 bits data must be even.
When edit the address, you can not select an odd address.
To Next Page
Loading...