RIGOL
© 2008 RIGOL Technologies, Inc. VII
User‟s Guide for Logic Signal Output Module
Catalog
Safety Notices .......................................................................................... II
Logic Signal Output Module at a Glance ...................................................... V
Chapter 1 Quick Start ............................................................................ 1-1
Ports of the Module ............................................................................... 1-2
To Connect the Module .......................................................................... 1-5
User Interface ....................................................................................... 1-8
Communication Protocol Interface .................................................... 1-9
Data Edit Interface ......................................................................... 1-11
Chapter 2 To Edit Digital Waveform ...................................................... 2-1
Protocol Setting ..................................................................................... 2-2
To Set RS232 Protocol ..................................................................... 2-3
To Set SPI Protocol ......................................................................... 2-5
To Set IIC Protocol .......................................................................... 2-7
To Set PO Protocol .......................................................................... 2-9
To Set the Code Pattern ........................................................................ 2-12
Common Code Pattern ................................................................... 2-12
User Define Code Pattern ............................................................... 2-13
User Data Editor ................................................................................... 2-14
Edit Address and Data .................................................................... 2-14
Edit Stored Digital Waveform .......................................................... 2-16
Data Browse, Store and Recall ........................................................ 2-17
Output User Data ........................................................................... 2-24
To Set the Output Data Length .............................................................. 2-27
To Set the Data Transmission Rate ......................................................... 2-28
To Set the Trigger Mode ........................................................................ 2-31
Channel Setting .................................................................................... 2-35
Channel Setting for RS232 Protocol ................................................. 2-35
Channel Setting for SPI Protocol ...................................................... 2-37
Channel Setting for IIC Protocol ...................................................... 2-39
Channel Setting for PO Protocol ....................................................... 2-41
Digital Waveform Calibration .................................................................. 2-43
Chapter 3 Examples .............................................................................. 3-1
Example 1: To Generate a RS232 Digital Waveform .................................. 3-2
Example 2: To Generate a SPI Digital Waveform ....................................... 3-4
Example 3: To Generate an IIC Digital Waveform ..................................... 3-6
To Next Page
Loading...
Need help?
General