Rigol DG3000 Series

RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for Logic Signal Output Module
2-31
To Set the Trigger Mode
The module provides 2 trigger modes: Auto and Burst, the default is Auto mode.
1. Auto trigger
Press Arb  Edit Digital W  F5  Trigger, to enter the interface as shown in
Figure 2-31. To change the trigger mode; turn to Burst mode.
Figure 2-31 Set Auto trigger mode
2. Burst mode trigger
Burst trigger includes 3 modes with respect to different trigger sources: Internal,
External and Manual. In Burst mode, the screen will also display the current
protocol in use and the related parameters.
1) Internal trigger
Press Burst  Source  Internal, to enter the interface as shown in Figure
2-32.