RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for Logic Signal Output Module
Troubleshooting
1. If digital module does not work after DG3000 powering up, please
follow the steps below:
(1) Turn off the instrument, check if the connection cable is correctly connected.
(2) Turn on the instrument, check if the Digit-Modu option has set to be
“Power-On”.
(3) If it does not work correctly, contact RIGOL for our service.
2. If all the settings are correct, but no waveforms output, please follow
the steps below:
(1) Check if the SMB-to-SMA RF coaxial line or logic analyzer testing lines you are
using are correctly connected.
(2) Set the Power On option to be Last when all the above steps have been
finished.
(3) Restart the instrument.
To Next Page
Loading...