Rigol MSO5074 User Manual

Chapter 13 Pass/Fail Test RIGOL
MSO5000 User Guide 13-1
Chapter 13 Pass/Fail Test
During the product design and manufacturing process, you usually need to monitor
the variations of the signal or judge whether the product is up to standard. The
pass/fail test function of MSO5000 series oscilloscope can accomplish this task
perfectly.
Contents in this chapter:
◼ To Enable or Disable the Pass/Fail Test
◼ To Start or Stop the Pass/Fail Test Operation
◼ To Select the Source
◼ To Create a Mask
◼ To Save the Mask
◼ To Load a Mask
◼ To Set the Output Form of the Test Results
◼ To Enable or Disable the Display of the Statistics of the Test Results
◼ Statistics Reset

Rigol MSO5074 Specifications

General

Bandwidth	70 MHz
Channels	4
Timebase Accuracy	± 2 ppm
Operating Temperature	0 °C to +40 °C
Display	800x480
Waveform Capture Rate	500, 000 wfms/s
Vertical Resolution	8 bits
Interfaces	USB Host, USB Device, LAN, HDMI
Input Impedance	1 MΩ
Trigger Types	Edge, Slope, Pulse, Video, Pattern, Duration, Timeout, Window, Runt
Sample Rate	8 GSa/s