EasyManuals Logo

Rigol MSO5074 User Manual

Rigol MSO5074
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #338 background imageLoading...
Page #338 background image
RIGOL Chapter 20 System Utility Function Setting
20-2 MSO5000 User Guide
Remote Interface Configuration
MSO5000 series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press Utility IO LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Figure 20-1 Network Connection Setting Interface
Network Status
Different prompts will be displayed according to the current network connection
status.
Network Config Succeeded!
Acquiring IP...
IP Conflict!
Disconnected!
DHCP Config Failed!
Read Status Fail!
Connected!
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control

Table of Contents

Other manuals for Rigol MSO5074

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol MSO5074 and is the answer not in the manual?

Rigol MSO5074 Specifications

General IconGeneral
Bandwidth70 MHz
Channels4
Timebase Accuracy± 2 ppm
Operating Temperature0 °C to +40 °C
Display800x480
Waveform Capture Rate500, 000 wfms/s
Vertical Resolution8 bits
InterfacesUSB Host, USB Device, LAN, HDMI
Input Impedance1 MΩ
Trigger TypesEdge, Slope, Pulse, Video, Pattern, Duration, Timeout, Window, Runt
Sample Rate8 GSa/s

Related product manuals