rletech.com WiNG-MGR v2 User Guide 31
3 Web Interface
3.2.1.4 Sensor Configuration
Use this page to configure your sensor. All fields in the following table will not be available
for each sensor. Only the configurable options that apply to each sensor are displayed in that
sensor’s configuration menu.
If you wish to configure settings globally for your sensors, that option is available on the
Admin > Alarms page and is detailed in section 3.7.5, “Alarms” on page 62.
NOTE
When the desired edits have been made, click the Save Changes button to save the
changes. If the Save Changes button is not selected, the new configuration will not be
updated and saved.
Figure 3.11
Individual Sensor Page - Sensor Configuration Tab
Option Description
General Info
Sensor Name Enter a name for this sensor.
Location Enter the sensor’s physical location.
Alarm Notifications
Temp Over Enter a high temperature alarm threshold - if the temperature rises
above this value, a high temperature alarm is generated.
Temp Under Enter a low temperature alarm threshold - if the temperature drops
below this value, a low temperature alarm is generated.
Humidity Over Enter a high humidity alarm threshold - if the humidity rises above
this value, a high humidity alarm is generated.
Humidity Under Enter a low humidity alarm threshold - if the humidity drops below
this value, a low humidity alarm is generated.
Table 3.4
Individual Sensor Page - Sensor Configuration Tab Options
To Next Page
Loading...