40 WiNG-MGR v2 User Guide 800.518.1519
3 Web Interface
Default Route The WiNG-MGR is shipped with a default Gateway Route of
10.0.0.1. Contact your IT Department for an appropriate Default
Gateway, if you wish to change this field.
Default device route: 10.0.0.1
HTTP Port Some ISPs use alternate http ports as an added security measure.
Edit this field in accordance with your ISPs security settings.
Default: 0 = Port 80
DHCPv4 Status Indicates whether DHCPv4 is enabled or disabled.
IPv6 Settings- Configure these fields if the WiNG-MGR is communicating via IPv6. You do
have the option in this section to use DHCP. If you do choose to enable DHCP, DHCP will
override any static options you configure.
IPv6 Click the Enable button to enable IPv6.
IPv6 Mode Choose the appropriate IPv6 mode:
Auto – Obtains the IP address using SLAAC (Stateless Address
Autoconfiguration)
Static – Allows you to manually enter a static IPv6 Address
Link Local Only – Uses the Link Local IP address and does not
enable a Global IPv6 Address. Packets will not be forwarded by
routers.
Note: Enabling Auto will override any static address information
saved in the IPv6 fields.
Static Address If you choose not to use DHCP, Enter a static IPv6 address in this
field.
Static Router Enter static router information here.
Prefix Length If the static address has a prefix, enter the bit length of the prefix
here.
Option Description
Table 3.7
IP Configuration Options
To Next Page
Loading...
