rletech.com WiNG-MGR v2 User Guide 59
3 Web Interface
Display Readings Select whether readings display in English (°F, feet, inches of water)
or Metric (°C, meters, Pascals) values.
Default: English
Logged Points Data logging can be seen on each sensor’s individual sensor page.
Both temperature and humidity will be logged every 5 minutes with
temperature to 0.1 degree.
Default: Off
Low Battery Alarm The low battery alarm alerts you to a drop in battery voltage so you
can change the batteries while the sensor is still active.
To ensure monitoring continuity, set this alarm to 3.1 Volts and
change the battery once the threshold is reached.
Default: 0 (disabled)
Sensor CSV File
Upload Sensor CSV Upload a CSV file to configure sensors in mass on this unit. This
feature is particularly helpful if you are configuring multiple identical
WiNG-MGR systems simultaneously.
Note: You can upload a CSV file downloaded from a WiNG-MGR v1
into a WiNG-MGR v2. Not all of the configuration settings will
transfer, but the sensor names and locations will upload.
Download Sensor
CSV File
Download a CSV file that shows all sensors configured in the
WiNG-MGR.
Delete Sensors
Delete Selected
Sensors
If you wish to delete some sensors monitored by the WiNG-MGR
without deleting all the sensors, use this option. Enter the range of
sensors you wish to delete, and click the Delete button. If you wish to
delete one specific sensor, enter that sensor’s number as both the
start and end points for the sensor range.
Delete All Sensors This command erases all the information about the sensors the
WiNG-MGR is currently monitoring. Users will have to reinstall
sensor information after the button is clicked, or rediscover sensors
already deployed.
Delete All Sensor
Data Logs
Click this button to delete all logged data for all the sensors
associated with this system.
Add A Sensor Click this button to add a sensor to the system. You will be asked to
enter the serial number of the sensor you’re adding, so be sure to
have the sensor’s serial number on hand. Click the Save Changes
button to add the sensor.
Attribute Description
Table 3.20
Sensor Configuration Options
To Next Page
Loading...
