7
Confi guration
Plugging in and language selection
Your radio may be confi gured using either the display and buttons on the radio, or by using
the UNDOK app.
1. Place your radio on a fl at surface and plug the cable from the mains adaptor into the
DC input socket located underneath the radio (marked 'DC In') ensuring that the plug
is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into the RJ-45
socket at the back of the radio. Ensure that the Stereo mode switch is in the centre
'Auto' position.
3. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting the radio to the
mains supply. The mains socket used for the radio must remain accessible during
normal use. In order to disconnect the radio from the mains, the mains adaptor should
be removed from the mains socket outlet completely.
4. When you apply power, the display on the radio will light up and show a start up screen
for a few seconds.
If this is the fi rst time that you use your radio (or after a Factory Reset) the display will
then show 'Setup wizard' and 'YES' will be highlighted on the screen.
Note: If you wish to use UNDOK to setup your radio, please see page 15.
5. By default your radio will display all menus and messages in English.
If English is your preferred language then press the Select button to select 'YES' and
to begin setting up your radio. If you selected 'YES' please skip to step 1 on page 9.
6. If your preferred language is not English, then press the Tuning Up or Down buttons
so that the 'NO' option is highlighted. Press the Select button to enter the selection.
Continue on the next page.
Setup wizard
Start now?
Setup wizard
Start now?
6
6
Select
i /
5,6
2
To Next Page
Loading...
