Rockwell Automation RELIANCE ELECTRIC SP500 - APPENDIX D Compliance with Machinery Safety Standard EN-60204-1:1992; D.1 Compliance with Machinery Safety Standard EN-60204-1:1992

Compliance with Machinery Safety
Standard EN-60204-1:1992
The SP500 AC Speed Controller for Electric Motors complies with the following
sections of Machinery Safety Standard EN-60204-1:1992.
EN-60204-1
Section Title
6 Protection against electrical shock
6.2.1 - Protection by enclosure
6.2.3 - Protection against residual voltages
6.3.1 - Protection by automatic disconnect of supply
6.4 - Protection by the use of PELV (Protective Extra Low Voltage)
7 Protection of equipment
7.2 - Overcurrent protection
7.2.3 - Control circuits
7.2.6 - Transformers
7.5 - Protection against supply interruption or voltage reduction and subsequent restoration
8 Equipotential bonding
8.2.1 - General (the PE terminal)
8.2.2 - Protective conductors (connection points)
8.2.3 - Continuity of the protective bonding circuit
8.2.7 - Protective conductor connecting points
8.3 - Bonding of the protective bonding circuit for operational purposes
8.4 - Insulation failures
8.5 - Bonding to a common reference potential
8.6 - Electrical interferences
9 Control circuit and control functions
9.1.4 - Control circuit supply
9.1.3 - Protection
9.1.4 - Connection of control devices
9.2 - Control functions
9.2.1 - Start function
9.2.2 - Stop function
9.2.3 - Operating modes
9.2.5 - Operation
9.2.5.3 - Stop
9.2.5.6 - Hold-to-run controls
9.2.6 - Combined start and stop controls
Compliance with Machinery Safety Standard EN-60204-1:1992 D-1