Rockwell Automation RELIANCE ELECTRIC SP500 - 7.5 Monitor Mode

A sample program mode display is shown in figure 7.3.
re -
Mm a
i
Mode Forward
RUN Enter Reverse
i)
tt
Bild
L_] RPM
[| %Load Program
LI Volts Forward STOP
START a
L_] Remote Reverse RESET
Ne /
Figure 7.3 — Example of a Program Mode Display
For information about: Refer to section:
Displaying or changing parameter values 8.1
Ensuring program security 8.2
Individual parameters 8.3
Accessing the error log 9.4
7.5 Monitor Mode
Monitor mode is the keypad and display’s default mode of operation (in other words,
the keypad and display will return to monitor mode when you exit program mode). The
keypad and display must be in monitor mode before the drive can be put into run (RUN
LED is on) and will remain in monitor mode while the drive is running.
The following output data can be displayed in monitor mode:
°* RPM
* %Load
* Volts
* Percent Selected Speed Reference (if F-13 = ON)
To select a value to monitor, press the MODE/ENTER key until the LED turns on next
to the desired display item. Pressing the MODE/ENTER key will advance you through
each of the displays. (Note that all the LEDs will turn on to indicate the percent
selected speed reference display if parameter F-13 is set to ON. Refer to section
7.5.2.)
Keypad and Display Operation 7-5