Rockwell Automation RELIANCE ELECTRIC SP500 - Auto-Restart Retry Wait Time; Drive Voltage Selection; Analog Output Select; Version Information

F-27 Auto-Restart Retry Wait Time
This parameter Parameter Range: 1 to 30 seconds
specifies the amount we
of time the drive will Default Setting: |
wait between auto- Step Size: 1.0 second
restart attempts.
This parameter is used with parameter F-26 (Auto-Restart Number of Attempts). Refer
to the F-26 parameter description for information regarding this feature.
F-28 Drive Voltage Selection
This parameter Parameter Range: N/A
displays the drive’s a
voltage rating. Default Setting: N/A
Step
Size: N/A
ATTENTION: This parameter is set at the factory and must not be
changed by the user.
F-29 Analog Output Select
This parameter selects Parameter Range: SPd = Current RPM/speed output
which monitor mode
value is directed to the
analog output UOL = Current calculated output voltage
(regardless of which
monitor mode value is
displayed). Default Setting: SPd
Step Size: N/A
LOAd = Current percent load output
rEF = Current percent of selected reference
Refer to table A.5 in Appendix A for more detail about the analog output.
F-49 Version Information
This parameter Parameter Range: N/A
displays the software a
version. Default Setting: N/A
Step Size: N/A
Programming Reference 8-17