Rockwell Automation RELIANCE ELECTRIC SP500 - CHAPTER 8 Programming Reference; 8.1 Displaying or Changing Parameter Values

8.1
Programming Reference
To program the SP500 drive for a specific application, you display the appropriate
parameter and adjust it as required. The parameters specify characteristics of the
drive. This chapter describes how to access, display, and modify parameters. Section
8.3 describes each parameter in detail. Appendix C lists the parameters in
alphabetical order.
Displaying or Changing Parameter Values
Use the following procedure to display or change parameter values:
Step 1. Stop the drive (if it is running) by pressing the STOP/RESET key.
Step 2. Enter program mode by pressing the MODE/ENTER key until the
PROGRAM LED turns on.
0) ~~) The first parameter number (F-00) will be
(| fee
C RPM [1 RUN (| fee
[1 %Load Ml Program
[5 Volts [5 Forward START STOP
[J] Remote [_] Reverse RESET
Step 3. Press the mor “W key until the desired parameter number is
displayed.
|) ~~] Each parameter number will be displayed as
you scroll through the parameter list.
(| (os
[ RPM [1 RUN (| (os
[1 %Load lll Program
C5 Volts [3 Forward START STOP
[5 Remote [_] Reverse RESET
Programming Reference 8-4