Rockwell Automation RELIANCE ELECTRIC SP500 - Page 70

Step 4. Press the MODE/ENTER key to display the parameter value.
S02
(| fe
C RPM [1 RUN (| fe
[1 %Load Ml Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Step 5. Press the Mm or “W key to change the value.
Note that if programming has been disabled
(a) ~~) in parameter F-20 (Password Lockout
Si) Enable), the value will not change. Refer to
(=) section 8.2, Ensuring Program Security, for
Forward
[J RPM (3 RUN (te i j j
J %Load lll Program inter leverse more information.
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Step 6. Press the MODE/ENTER key to save the changed value.
The parameter number is displayed again.
JS
(t= fener
CI RPM [1 RUN (t= | fener
[5 %Load = Ml Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
To display or change additional parameters, repeat steps 3 through 6.
To exit program mode, press the MODE/ENTER key until a parameter number or
ERR is displayed; then press the STOP/RESET key.
Important: Parameter values and the keypad status (local or remote) are retained
through a line dip or power loss.
8-2 SP500 AC Drive Installation and Operation Manual Version 3.1