Rockwell Automation RELIANCE ELECTRIC SP500 - 8.3 Parameter Descriptions

8.3 Parameter Descriptions
F-00 Control Source Select
This parameter selects Parameter Range: 0= Local control; control signals and speed reference from
the drive control the keypad
source and speed
reference source. 1 = Remote control; control signals from the terminal strip;
speed reference from the analog input
2= Remote control; control signals from the terminal strip;
speed reference from the keypad
3= Remote control; control signals from the terminal strip;
multi-speed presets from the terminal strip
Default Setting: 0= Local control
Step Size: N/A
When F-00 = 0, the drive responds to sequencing commands (start, stop, forward,
reverse) from only the keypad.
When F-00 = 1, 2, or 3, the drive responds to sequencing commands from the
terminal strip. Note that the drive will respond to the stop command from the keypad
regardless of the value in this parameter.
Refer to the F-23 to F-25 Multi-Speed Presets parameter description for more
information about multi-speed presets.
F-01 Acceleration Time
This parameter Parameter Range: 0.5 to 90 seconds
specifies the amount
of time it takes the
motor to ramp from Step Size: 0.10 seconds
stop to the maximum
speed setting in F-04.
Default Setting: 5.0 seconds
If the setpoint frequency requested from the keypad (using the and “W keys) is
less than the maximum speed setting, the time to ramp to that frequency will be
proportionally less than the actual rate setting. For example, if F-04 = 60Hz and F-01
= 4 seconds, it will take 2 seconds to ramp to a frequency reference of 30 Hz.
Note that if the acceleration rate is set too fast, an overcurrent fault may occur (OC will
be displayed).
F-02 Deceleration Time
This parameter Parameter Range: 0.5 to 90 seconds
species me amour Default Setting: 5.0 seconds
to ramp from the Step Size: 0.10 seconds
maximum speed
setting in F-04 toa
stop.
Programming Reference 8-5