Rockwell Automation RELIANCE ELECTRIC SP500 - Page 72

Step 3. Press the @ key until the password number, 257, is displayed. (Holding
down the .@ key increases the scroll speed.)
asia =
(| fe
C RPM [1 RUN (| fe
[1 %Load Ml Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Step 4. Press the MODE/ENTER key to save the password number.
ON or OFF is displayed to indicate the
(| id current state of the password lockout.
(te fae
CI RPM [1 RUN (te | fae
[5 %Load Ml Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Step 5. Press the MODE/ENTER key to exit the parameter.
The parameter number is displayed again.
ae
(tz fener
CI RPM [1 RUN (tz | fener
[5 %Load = Ml Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Important: There is no visual indication of the status of this feature. You must access
F-20 to verify its current value (ON or OFF).
8-4 SP500 AC Drive Installation and Operation Manual Version 3.1